Innotech Genesis II Digital Controller (v5) Instrukcja Użytkownika Pobierz pdf (Strona 106)

Genesis II Installation Instructions

Page 106 © Mass Electronics Pty Ltd 2010Edition 2.0 dated 06/12/2013

5-3.3.1 Adding Modules to the Comms Link

To insert another module into the Comms link, make a looping connection through it as in Example

A of Figure 5-2 below. Alternatively, use a Innotech Repeater IR11 or IR12 to branch o to the new

module as in Example B of Figure 5-2.

Note that the four devices and Port 1 of the Repeater Module are connected in bus topology. Port 2 of

the Repeater Module and the added device form a separate network linked by the electronics within

the Repeater Module. Always maintain bus topology on the network when adding another module to

the network.

5-3.3.2 Linking Networks in Dierent Locations

When linking networks in dierent buildings, or when linking modules supplied from dierent

switchboards, isolation must be provided to eliminate earth loops.

To expand an REM network, use an Innotech Repeater IR11 as described below in section 5-3.3.3.

To expand a Primary Network, use an Innotech Repeater IR12 as described in subsection 5-3.3.4.

Figure 5-2: Adding Modules to a Network

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 123 124

Brak uwag

Innotech Genesis II Digital Controller (v5) Instrukcja Użytkownika Strona 106