Innotech Device Network Cabling Instrukcja Użytkownika Pobierz pdf (Strona 31)

Innotech Device Network Cabling Installation Instructions

Chapter 3 – Sub Network Devices

Page 31

EXAMPLE 2:

This example shows a GENIIELD controller with a network of REM’s and an IR11 repeater fitted.

As in section one, once a repeater is installed there are eectively two networks and each must have

the EOL jumpers fitted.

Both ends must have the EOL jumpers fitted.

NOTE

Figure 3-3: REM Network with Repeater

EXAMPLE 3:

This example shows a GENIIELD controller with a network of REM’s where the controller is in the

middle of the run.

Figure 3-4: REM Network with Controller in the Middle of the run

Both ends of a run muse have the EOL jumpers fitted. It does not need to be a primary device.

NOTE

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 45 46

Brak uwag

Innotech Device Network Cabling Instrukcja Użytkownika Strona 31